VCS VIP 10 Guía de usuario descargar pdf (Pagina 51)

Chapter 6 Configuring the Sender

VIP 10 51

Note

The video sensor monitors Stream 1. For exact motion detection it is

recommended to choose CIF as video resolution for Stream 1 (see

page 41).

In order for the sensor to function, the following conditions must be met:

] The motion detector must be enabled.

] At least one sensor field must be activated.

] The individual parameters must be set for the operating environment and the

desired responses configured accordingly.

] The sensitivity must be set to a value greater than zero.

Warning!

Reflections of light (off glass surfaces, etc.), switching lights on or off or

changes in the light level caused by cloud movement on a sunny day can

trigger unintended responses from the video sensor and generate false

alarms. Run a series of tests under day and night conditions to ensure that

the sensor works as intended.

For indoor surveillance, ensure constant lighting of the areas during the day

and at night.

Uniform surfaces without contrast can trigger false alarms even with

constant lighting.

Note

Clicking the Defaults button will reset the video sensor to its factory

configuration.

Motion detector

Select On to activate the video sensor.

Select sensor fields

The areas of the image to be monitored by the video sensor can be selected. The

video image is subdivided into 396 square sensor fields. Each of these fields can

be activated or deactivated individually. If it is necessary to exclude particular

regions of the camera's field of view from monitoring due to continuous

movement (by a tree in the wind, etc.), the relevant fields can be deactivated.

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 121 122

Sin comentarios

VCS VIP 10 Guía de usuario Pagina 51