VCS VIP 10 Manual de usuario descargar pdf (Pagina 125)

VIP X1 | Installation and Operating Manual EN | 125

Bosch Security Systems | 2006-12 | V2.5 Appendix

iSCSI connections malfunctions

The unit does not

report an alarm.

Alarm source is not selected. Select possible alarm sources on

the Alarm sources configuration

page.

No alarm response speci-

fied.

Specify the desired alarm response

on the Alarm connections config-

uration page, change the

IP address if necessary.

Control of cameras

or other units is not

possible.

The cable connection

between the serial interface

and the connected unit is not

correct.

Check all cable connections and

ensure all plugs are properly fitted.

The interface parameters do

not match those of the other

unit connected.

Make sure that the settings of all

units involved are compatible.

The unit is not opera-

tional after a firm-

ware upload.

Power failure during pro-

gramming by firmware file.

Have the unit checked by Cus-

tomer Service and replace if nec-

essary.

Incorrect firmware file. Enter the IP address of the unit fol-

lowed by /main.htm in your Web

browser and repeat the upload.

Malfunction Possible causes Solution

No LUNs are dis-

played after connec-

tion to the iSCSI

server.

Incorrect LUN mapping dur-

ing iSCSI server configura-

tion.

Check the iSCSI server configura-

tion and reconnect.

„LUN FAIL“ is dis-

played below a node

after connection to

the iSCSI server.

The LUN map was not read-

able as it was assigned to

the wrong network interface.

Check the iSCSI server configura-

tion and reconnect.

LUN mapping is not

possible.

Some iSCSI systems don’t

support initiator extensions.

Delete the initiator extension on the

iSCSI settings configuration page.

Malfunction Possible causes Solution

1 2 ... 120 121 122 123 124 125 126 127 128 129 130 ... 143 144

Comentarios a estos manuales

Sin comentarios

VCS VIP 10 Manual de usuario Pagina 125

Comentarios a estos manuales